Table of Contents
Advertisement
5. Place the transparency on the build tray, next to its left and rear edges,
6. Make sure that the transparency sheet is lying flat, and tape it to the
7. In the wizard screen, select the check box to confirm that the
8. When the following screen appears, remove the transparency.
DOC-22000 Rev. A
as shown in the following figure.
Figure 7-28:Positioning the transparency on the build tray
tray.
transparency sheet is placed on the build tray, and click
The Eden printer prints the head alignment test on the transparency.
Figure 7-29:Head Alignment wizard—steps 8–10
Eden250 User Guide
Next
.
7–21
Advertisement
Table of Contents
