Stratasys Eden250 User Manual page 83

2. Make sure that the computer network connecting the printer and Job
3. In the Job Manager interface, click the Resume icon
4. In the Continue from Slice dialog box that appears, confirm the slice
Printer mode
5. If, for any reason, the correct number does not appear in the dialog
You cannot continue printing the model if:
•
•
If you cannot continue printing:
1. Cancel the print job in Job Manager.
2. Remove the partially printed model from the build tray.
3. Send the job to the Eden printer again.
You can stop and resume printing from either the Eden printer interface or
the Job Manager interface, since both components are updated with this
command. However, the effect of using the Pause button in the printer
interface is local; you can only resume printing from the printer interface.
DOC-22000 Rev. A
Manager server is active.
number, after checking the Eden printer interface.
Figure 7-5: Eden interface after interrupted printing
Figure 7-6: Continue from Slice confirmation dialog box in server
(Job Manager) interface
box, enter the number and click
The number of the last slice printed does not appear in the Eden
interface, even if the server computer displays the Continue from Slice
confirmation dialog box.
There was a relatively long interruption in printing, even if the "last
slice" and "continue from slice" indicators are correct. The part of the
model already printed may deform or shrink, and there might be a
visible difference between it and the newly printed part. The effects of a
printing stoppage on a model depend on the model size and structure,
model material used, ambient temperature and the length of the
stoppage.
Eden250 User Guide
OK
.
.
Last slice
printed
7–7