Stratasys Eden250 User Manual page 109

•
Weight Calibration After the successful installation of a print head, the wizard begins the first
of two weight tests, in which each head prints a sample. This phase takes
about 25 minutes.
25. Carefully remove the samples for each head, keeping track of the head
DOC-22000 Rev. A
If the vacuum test is not successful, the replacement head was not
sealed properly during installation, and the following warning screen
appears.
Figure 7-53: Vacuum Leakage warning screen
If this happens:
Next
a. Click .
b. Follow the instructions on the wizard screens to re‐install the head.
Figure 7-54:High-quality-printing weight test progress screen
that printed them.
M1 M1 M0 S1
Figure 7-55:Samples printed on the Eden build tray
Eden250 User Guide
S1
7–33