Operating & Maintaining the Eden 3-D Printer
18. Push the head up until you hear it click into place, in both front and
19. Lower the door of the printing head compartment, and tighten the
20. Tighten the upper and lower screws that secure the printing head in
21. In the Head(s) Replacement screen (see figure 7‐38 on page 7‐27), select
22. With your fingers, make sure that the new head is level and even with
23. In the next wizard screen, select the check box to confirm that the new
7–30
rear holders.
Figure 7-46:Clicking the head into place in the print block
screws to lock it in place.
the printing block (see figure 7‐39 on page 7‐27).
Note: Hand-tighten these screws. Do not use a screwdriver.
the check box to confirm that the head has been replaced, and click
Next
.
the other heads.
Figure 7-47:Checking the level of the new head
head is level and even with the other heads, and click
Next
.
DOC-22000 Rev. A