Table of Contents
Advertisement
Operating & Maintaining the Eden 3-D Printer
5. Pull the lamp reflector out of the print block.
6. On the inside of the lamp reflector, a black strip covers part of the
7. Discard the old reflector and lamp, but save the black strip so you can
8. Fasten the black strip to the inside of the new UV lamp reflector, on the
7–36
Figure 7-61:Removing the UV lamp reflector
reflector. Remove this strip by sliding it off.
Figure 7-62:Removing the black strip from the old reflector
install it in the new reflector.
same side as it was in the old reflector.
Figure 7-63:Fastening the black strip to the UV lamp reflector
DOC-22000 Rev. A
Advertisement
Table of Contents
