Table of Contents
Advertisement
Important: The black strip must always be on the side of the reflector
opposite the print block.
9. Insert the new UV lamp/reflector into the housing next to the print
10. Replace the lamp cover by inserting it into the slot on the bottom of the
11. Reconnect the power connection to the UV lamp.
DOC-22000 Rev. A
block.
Figure 7-64:Printing block and UV lamp assembly, showing correct placement
of black strip
housing, and tighten the securing screw on top.
Figure 7-65:Replacing the lamp cover
Figure 7-66:Connecting power to the UV lamp
Eden250 User Guide
UV lamp
assembly
Print block
Black strip
7–37
Advertisement
Table of Contents
