Table of Contents
Advertisement
Operating & Maintaining the Eden 3-D Printer
Preparing the
5. Select the head(s) needing replacement, and click
print block
6. When the print block is completely drained, click
7. Take note of the warning screen that appears (see figure 7‐37). To
7–26
Figure 7-35:Head selection screen
The Eden printer heats and empties the heads. (This should take about
10 minutes.)
Figure 7-36:Emptying Block progress screen
prevent damage to the print block, you must install the new head
immediately after removing the defective one. Click
ready to continue.
Figure 7-37:Head Replacement warning screen
Next
.
Next
.
Next
if you are
DOC-22000 Rev. A
Advertisement
Table of Contents
