Set Up The Module With Mvd Direct Connect - Emerson Micro Motion Quick Start Manual

Quick Start Guide
1 Quick installation and startup
This procedure provides a summary of installation and startup steps. For
installation details, see the EtherNet/IP Module User Manual.
1.1 Components
Ensure that you have all required components:
• Micro Motion EtherNet/IP Module
• Power connector
• Micro Motion EtherNet/IP Resource CD
— Micro Motion EtherNet/IP Module User Manual
— EDS file
— MicroMotion Ethernet Config Tool
• Configuration cable
• Modbus serial cable and connector (included)
• Ethernet cable and connector (not included)
1.2

Set up the module with MVD Direct Connect

Use this procedure only if you are installing the module with MVD Direct
Connect.
Procedure
1. Mount and wire the core processor and barrier.
Figure 1-1: Barrier
2. Power up the core processor and barrier.
3. Set the Modbus address on the core processor to 1.
Postrequisites
Continue to
2
A. I.S. terminals for connection to core processor
B. Non-I.S. terminals for connection to remote host and power supply
Mount, wire, and set the network settings.
Micro Motion EtherNet/IP Module
January 2019