Limit Test Commands - Agilent Technologies 54753A Programmer's Reference Manual

Command
<source>
<destination>
<filename>
<format>

Limit Test Commands

:LTESt:SWAVeform[?]
<source>,<destination>,[,<filename>[,<format>]]
Saves waveforms from a channel, function, histogram, TDR response, or
waveform memory in the event of a failure detected by the limit test. Each
waveform source can be individually specified, allowing multiple channels or
functions to be saved to disk or waveform memories. Setting a particular
source to OFF removes any waveform save action from that source.
{CHANnel<number> | FUNCtion<number> | HISTogram
| RESPonse<number> | WMEMory<number>}
{OFF | WMEMory<number> | DISK}
When DISK is selected, a file name is required.
A descriptive file prefix consisting of up to four characters. If no filename is
specified, the prefix defaults to CH1A..CH4B, FN1, FN2, FFT, HIST,
MEM1..MEM4, RSP1..RSP4.
{TEXT [,YVALues | VERBose] | INTernal}
20