Agilent Technologies 54753A Programmer's Reference Manual page 35

Command
<source>
<number>
Command
<source>
<number>
Command
<source>
<number>
:MEASure:VLOWer[?] [<source>]
Measures the voltage value at the lower threshold of the waveform.
{CHANnel<number> | FUNCtion<number> |
RESPonse<number> | WMEMory<number>}
For channels: an integer, 1 through 4, indicating the slot in which the channel
resides, followed by an optional A or B identifying which of two possible
channels in the slot is being referenced. For functions: 1 or 2. For waveform
memories (WMEMory): 1, 2, 3, or 4. For TDR responses: 1, 2, 3, or 4.
:MEASure:VMAX[?] [<source>]
Measures the absolute maximum voltage present on the selected source
waveform. When FFT is the specified source, the maximum value in
spectrum is measured.
{CHANnel<number> | FUNCtion<number> |
RESPonse<number> | WMEMory<number> | FFT}
For channels: an integer, 1 through 4, indicating the slot in which the channel
resides, followed by an optional A or B identifying which of two possible
channels in the slot is being referenced. For functions: 1 or 2. For waveform
memories (WMEMory): 1, 2, 3, or 4. For TDR responses: 1, 2, 3, or 4.
:MEASure:VMIDdle[?] [<source>]
Measures the voltage value at the middle threshold of the waveform.
{CHANnel<number> | FUNCtion<number> |
RESPonse<number> | WMEMory<number>}
For channels: an integer, 1 through 4, indicating the slot in which the channel
resides, followed by an optional A or B identifying which of two possible
channels in the slot is being referenced. For functions: 1 or 2. For waveform
memories (WMEMory): 1, 2, 3, or 4. For TDR responses: 1, 2, 3, or 4.
Measure Commands
33