against the lens port. Make sure
not to scratch the lens port using
the lens port opening tool.
f. Separate the lens port from the
housing by pulling it out and away
from the housing.
g. Note that it is recommended to
store the lens port separated
from the housing during
transportation and storage.
h. To protect the housing during
storage and transportation, it is
recommended to mount the body
cap on the housing lens port hole
and secure it by turning it clockwise.
OPENING THE HOUSING
Important Notice
1. Pull the small red tab located at the bottom of the latch dial outwards (up and away from the
housing), as indicated by the arrow direction (image #19 on the following page). There is no
need to apply any force.
2. While holding the lock dial up, turn the latch dial counterclockwise until the red latch tab is
located at the top of the latch and cannot be turned any farther (image #20 on the following
page). There is no need to apply any force.
Prior to opening a vacuumed housing, the vacuum should be released
using the Vacuum Valve. For further instructions, please refer to the
section "Fantasea Hybrid Vacuum Safety System".
Image #18
23
FA6400 Housing Instruction Manual 20190416