Fantasea Line FA6400 Instruction Manual page 33

Identification of System Parts
Vacuum Valve
Protective Cap
Charging the Unit
1. Turn the unit on using the power switch
featured on the Signal Board.
2. The LED Indicator will start flashing blue:
a. Slow flashing (approx. 1 flash per
second) indicates a charged battery.
b. Rapid flashing (approx. 4 flashes per
second) indicates low battery.
3. To charge the unit, connect it to a USB
charger using a standard Micro‐USB cable
(not included). Note that it is best using an
android phone charger unit for this purpose.
4. Connect the micro‐USB end of the cable to the Micro‐USB port on the Signal Board (image #36).
Connect the other end of the cable to a USB port or USB charger.
5. The unit should start charging and the LED Indicator should start flashing green.
6. Make sure to keep the unit turned on during charging.
7. When charging is complete, the LED Indicator stops flashing and remains green.
8. Disconnect the cable and turn the unit off using the power switch on the Signal Board to save
battery power. If the unit is left turned on, the battery will drain within a few days.
9. During charging, keep the charger away from highly flammable materials or products and never
leave the charger unattended when in use.
10. Never apply any type of pressure on the battery, expose it to direct heat or chemicals.
11. Battery must not be charged in temperatures below freezing or above 50°C (122°F).
(Housing Back Door Exterior)
Vacuum Valve
Vacuum
Release Tip
Image #36
33
FA6400 Housing Instruction Manual 20190416