16. Lens Port Lock – When set to the "lock" position, the Lens Port Lock ensures that the fully closed lens
port doesn't accidently open during the dive. When set to the "unlocked" position, the lens port can
be removed and replaced. For further instructions regarding lens ports installation and removal
please refer to the section "Installing and Removing Lens Ports".
Important Notice
17. Tripod Mounting Screw Holes – Enable mounting the housing on a tray or tray & handle system,
thereby allowing for the addition of various image enhancement accessories. The 3 adjustment screw
holes provide flexibility with respect to the choice of tray and the position of the housing mounted on
it. This configuration also allows for the use of 2 set screws for the tray mount, thereby preventing
any swiveling of the housing on the tray.
Important Notice
18. Lens Release Control – Pushing this control presses the camera Lens Release button, which allows for
unscrewing a lens and removing it from the camera while the camera is accommodated inside the
housing. This is especially useful when using exceptionally large lenses which cannot be installed on
the camera prior to inserting it into the housing. In such cases, the lens should be installed and
removed through the lens port. For further instructions please refer to the section "Installing the
Camera".
The Lens Port Lock must not serve as an indication of a proper watertight
seal and does not ensure that the lens port was properly installed on the
housing. For lens port installation guidelines and double check procedures,
please refer to the section "Installing and Removing Lens Ports".
Screws longer than 7mm should not be screwed into the housing Tripod
Mounting Plate, as they might damage the plate and housing.
11
FA6400 Housing Instruction Manual 20190416