Fantasea Line FA6400 Instruction Manual page 26

Pull out the bottom of the LCD screen all the way out
(image #24). After camera installation, the LCD screen
should be realigned for a clear view.
7. Mount the camera on the tray by installing the
mounting screw featured on the tray into the mounting
screw hole found at the bottom of the camera (image
#25). Make sure to follow the diagram printed on the
tray and install the camera facing forward. Once the
screw has been tightened, make sure that the camera
is positioned steadily on the tray.
8. Note that the camera battery compartment can
be opened when the camera is installed on the
tray, allowing for easy and quick battery and
memory card replacement without having to
remove the camera from the tray.
9. Prior to installing the tray and camera into the
housing:
a. Make sure that the built‐in flash is
pushed down into the camera body.
Any attempt of installing the camera
into the housing with the flash popped‐
up might damage the camera and the
housing and will necessarily interfere with a proper watertight seal of the housing.
b. Make sure the camera is turned off and that the housing On/Off control is set at the
"Off" position as well.
c. Turn the AEL/AF/MF control on both the camera and the housing to AEL. Failing to do so
will disable the control once the camera is accommodated inside the housing.
d. Turn the Mode Dial so the same shooting mode is selected and aligned with the white
mark on the left of the wheel on both the camera and housing (image #26 on the
following page). This will allow for the camera and housing mode dials to be aligned, so
the housing mode dial will indicate the proper mode selected by the camera dial.
Image #24
Image #25
26
FA6400 Housing Instruction Manual 20190416