Table of Contents
Advertisement
Menu 2.5 Alarms, Warnings and Info
How to set up alarms
Different alarms can be set up. Choices are listed as follows.
Display text
Notes
[2.5.01 Volume rate]
Suggested setting is 10%
[2.5.02 Tank contents]
Measured in gallons
[2.5.03 Spray pressure]
High/low pressure
[2.5.04 Fan speed]
High/low rpm
[2.5.05 Speed]
Speed max.
[2.5.06 Wind speed]
Wind speed max./min.
[2.5.07 PTO revolutions]
PTO revolutions max./min.
[2.5.08 Air temperature]
Air temperature max./min.
[2.5.09 Relative humidity]
Relative humidity max./min value.
[2.5.10 RPM]
RPM max./min.
[2.5.11 Extra1]
Value (PPU) max/min
[2.5.12 Extra2]
Value (PPU) max/min
[2.5.13 Extra3]
Value (Volt) max/min
[2.5.14 Extra4]
Value (Volt) max/min
[2.5.15 Sections off warning]
Warning when sections are switched off
[2.5.16 Audio level]
Audio steps sound when moving from one step to
another.
When outside the alarm parameters, the relevant warning will flash in the lower left corner of the screen. The alarm beep
can also be adjusted in audio level in menu [2.5.16 Audio level]. Audio level can be selected in steps from 1 to 5. For no
alarm, set at 0.
Volume rate alarm for over or under application activates after 20 seconds.
For more details on alarms see "Fault finding".
Warnings
The warnings appear as shown. For more details on warnings see
"Fault finding".
6 - Menu 2 Setup
Area spray
ALARM
0
Track rear
acre
Work rate
sensor
0.00 1200
failure
acre/hour
Area spray
0
Warning
acre
Fan speed
Work rate
too low
0.00 1200
acre/hour
Prog. rate
500
gal/acre
Tank cont.
gallon
Prog. rate
500
gal/acre
Tank cont.
gallon
6.7
Hide quick links:
Advertisement
Table of Contents
