Daily Settings; System Start-Up; Lookahead Nozzle Choice - Hardi HC6500 Instruction Book

Daily settings

System start-up

When the HC 6500 is turned on, the controller initializes itself. If the Controller is being put into operation for the very first
time, it will prompt for date and time. Set clock to enable register. Refer to "Menu 2.4 Set clock" for details on setting of clock.
If LookAhead is enabled in the HC 6500, it will prompt user for a nozzle choice - see section "LookAhead nozzle choice".
If the pressure based regulation is enabled in the HC 6500, it will prompt user for a nozzle choice and minimum pressure -
see section "Pressure based regulation".

LookAhead nozzle choice

If LookAhead or pressure based regulation is enabled, the HC 6500 will
prompt user for a nozzle choice at every start-up of the controller.
The present selected nozzle is designated by the ‰ symbol at the line
of the nozzle description in the display.
If the nozzle used at last spray job is going to be re-used, then press ~
or #.
Selecting another nozzle:
1. Select another nozzle by pressing ¿ or ª.
2. Confirm the choice by pressing #.
If LookAhead is not calibrated, then the screen changes to menu [3.7.1.1
Application rate]. Enter the expected application rate and press # to
spray and calibrate. Then prepare for calibration - see menu [3.7
LookAhead] for details on this.
4 - System setup
1.6 LookAhead nozzle select
>> 1.6.01 Pink ISO 0075
1.6.02 Orange ISO 01
1.6.03 Green ISO 015
1.6.04 Yellow ISO 02
1.6.05 Lilac ISO 025
1.6.06 Blue ISO 03
1.6.07 Red ISO 04
1.6.08 Brown ISO 05
1.6.09 Grey ISO 06
Select nozzle for ISO 0075 0,3 l/min
at 3 bar (0.075 gal/min at 40 psi)
3.7.1.1 Application rate
15.00
gal/acre
Type in planned application rate.
Press Enter to spray and calibrate
4.5