Malaguti Blog 126 Service Manual page 22

B l o g B l o g B l o g B l o g B l o g
125 - 160 cc
LIGHT BULB REPLACEMENT
HEADLIGHT
• In order to access the headlight bulbs, refer to the topics at page (33).
TURN SIGNALS
FRONT: See page (33).
REAR: Undo the screws (V) and remove the rear reflectors. Turn the bulb anti-clockwise and replace it by a new
identical one.
TAIL LIGHTS
• Undo the screws (V") and remove he tail light cover. This operation will allow releasing the whole light unit (body +
cover).
NUMBER PLATE LIGHT
• Undo the screw (W) and remove the tail light cover (F).
• Remove the rubber bulb holder from the plastic cover and
replace the bulb.
NOTE - Before reassembling any component removed to
replace one or more bulbs, check the light opera-
tion.
LIGHT BEAM ADJUSTMENTS
To check/adjust the beam, proceed as follows:
• Put the vehicle in running conditions at 10 metres from a wall.
• Turn the low beams on and keep the vehicle vertical, without stand or driver.
• Using an adjustable spanner, turn the projector screw (R), bearing in mind that turning anti-
clockwise raises the beam and vice versa.
F
W
F. 28
22 03/09
V
F. 27
R
F. 29
F
V
V
2