Malaguti Blog 126 Service Manual page 16

B l o g B l o g B l o g B l o g B l o g
125 - 160 cc
BLEED BRAKE SYSTEM
FRONT CALIPER
NOTE - Position the vehicle in a stabile manner and
perfectly on level ground.
• Remove the (right side) oil pump reservoir cover
(A), unscrewing the relative screws (V"), in order to
be able to top off the fluid.
• Fill the right brake fluid reservoir (B) to the highest
level.
• Remove the rubber hood (C) of the bleeder screw
(V) and insert a rubber tube to recover the brake
fluid.
• Pump the right brake lever (D), prime it and bring
the system in pressure.
• Keeping the brake lever pumped, loosen the blee-
der screws (V), to allow air to escape. Then, tighten
the bleeder screw (V).
• Repeat the operation, until only liquid comes out of
the rubber tube.
• Top up the brake fluid level in the reservoir (B).
REAR CALIPER
• To bleed the rear caliper, follow the same operation
above, but pump the left brake lever (S).
A
D
F. 13
V
12 ± 16%
A V
B
S
F. 15
16 03/09
V
2
B
F. 14
C
2
V
F. 16
C
V