Installation Of The Exhaustion Accessory And Admission Of Air - Bosch Therm 6000 S Installation And Operating Instructions Manual

18 | Installation instructions
5.8 Installation of the exhaustion accessory and
admission of air
It is mandatory the installation of the
accessories for the exhaustion / admission of
air, cód. 7 709 003 734 (system of
admission / exhaustion Ø80/80 mm).
For the installation of the accessory they should be following
the manufacturer's instructions.
WARNING:
▶ This appliance is required to be
connected to a dual duct flue system
incorporating separate paths for
provision of the combustion air and the
exhaust of the combustion products to
and from the exterior of the building.
Note the manufacturer's specific
instructions regarding installation of the
appliance.
5.8.1 Installation of the accessory of admission of air
To install the accessory of admission of air, proceed as follow;
▶ Put the gasket between the appliance and the accessory
(Fig. 27, [1].
▶ Tighten the 4 screws of the accessory of admission of air
(Fig. 27, [2]).
2.
2.
1.
Fig. 27
6 720 800 095 (2015/11)
2.
2.
6720608920-24.1AL
5.8.2 Installation of the exhaustion accessory Ø 80mm
To install the accessory of the exhaustion accessory, proceed
as follow;
▶ Put the gasket between the appliance and the accessory
(Fig. 28, [1]).
▶ Tighten the 3 screws of the exhaustion accessory (Fig. 28,
[2]).
2.
Fig. 28
2.
2.
1.
6720608920-25.1AL
Therm 6000S