Remote Control Connection (Optional); Electrical Connection (Only By Authorised Technicians); Connecting The Power Cable - Bosch OptiFlow Professional GWH12 1 CTD E23 F3 OL Installation Manual

4.7

Remote control connection (optional)

Connecting the communication cable to the remote control
▶ Open the remote control.
▶ Remove the larger connector from the communication
cable.
▶ Connect the larger connector to the controller in the
position shown in Fig. 7.
▶ Remove the plastic tag to allow the cable to be feed
through.
▶ Feed the end of the cable without a connector through the
opening in the back cover.
▶ Reconnect the cable to the larger connector.
▶ Refit the front and back covers back together.
▶ Close the remote control.
1
2
Fig. 6
[1] Remote control front cover
[2] Remote control back cover
[3] Communication cable
OptiFlow Professional
3
1.
6720806426-03.1V

Electrical connection (only by authorised technicians) | 13

Connecting the communication cable to the appliance
▶ Connect the communication cable to the appliance.
Fig. 7
The remote control connection is concluded.
5 Electrical connection (only by authorised
technicians)
DANGER: Due to electric shock!
▶ Before carrying out work on electrical
components, disconnect the power
supply (230 V AC) (fuse, circuit
breaker) and secure against
unintentional reconnection.
All the regulating, control and safety devices in the appliance
are factory supplied already connected and ready to operate.
CAUTION: Electrical storm!
▶ The appliance must have an
independent connection in the electric
box, protected by a differential safety
switch of 30 mA and ground line. In areas
with frequent electrical storms, a
protector against electrical storms must
also be fitted.
5.1

Connecting the power cable

The electrical connection must be done in
accordance with AS/NZS3000.
1.
6720808877-04.1V
6 720 810 559 (2016/06)