Use of optional remote control
Fig. 32 Remote control
The wireless remote control accessory and the
temperature selector buttons on the front of the water
heater operate identically. Contact your installer or
distributor to order the remote control accessory.
Modification of the water heaters interior control unit
(Fig. 48, component 25) is required when installing the
remote control with this heater.
NOTE: up to 6 remote controls can be
programmed for one single water heater,
each with a range distance of 98 ft (30 m).
B When a hot water tap is opened, main burner ignites
and LCD displays indication
B LCD blinks until selected temperature is reached.
If display blinks continously, heater cannot maintain
or achieve selected temperature.
If the LCD displays the error symbol
do not shut off power or unplug the heater.
Record the error code displayed on LCD and consult
"Troubleshooting" section (Section 6.8, page 36).
6 720 608 263
and error code
B press reset button in order to return heater to normal
Fig. 35 Reset button
If the problem persists or error code will not reset,
contact your installer.
The program button can be used on the appliance and
on the remote control.
Programming "Program" function
Programming actions are similar for both controls
(appliance control pad and wireless remote control).
Fig. 36 "Program"
B Press buttons
B Hold "Program"
When LCD stops blinking, selected temperature has
Using "Program" function
In order to select memorized temperature
B Press "Program" key.
LCD shows pre-memorized temperature, which is now
the hot water selected temperature.
This condition is only valid for appliances utilizing one or
more remote controls.
Fig. 37 Locked condition
Whenever LCD shows
cannot be adjusted because the appliance is in use by
a user which already selected a different temperature.
Appliance will be automatically unlocked after closing
hot water tap.
to select temperature to be
button for 3 seconds to save
the temperature setting