Table of Contents
Advertisement
For ease of installation it is recommended
that the water be connected followed by the
rest of the connections.
5.6
Water connection
▶ Mark the hot and cold water pipes in order to avoid
confusion.
Fig. 25
[1] Hot water
[2] Cold water
▶ Make the hot and cold water connection.
▶ In order to prevent problems caused by sudden inlet
pressure changes, the inclusion of an anti-return valve is
advised when installing the appliance.
5.7
Gas connection
DANGER:
▶ If local regulations are not follow exactly,
a fire or explosion may result causing
property damage, personal injury or loss
of life.
Only use accessories recommended in this
manual.
The gas connection must fulfil local regulations.
Therm 6000S
When the installation is effected with non-metallic, flexible
tubes for use with bottled Butane, the following should be
observed:
•
the tubes should be as short as possible and no longer than
1.5 m;
•
the tube should be to IPQ ET 1038 standard and fulfil all
applicable regulations;
•
it should be accessible for inspection along its entire
length;
•
it should not be located near heat sources;
•
bends and other obstructions should be avoided;
•
the ends should be secured with adequate accessories and
clamps;
▶ Tubes must be replaced every four years or whenever it
becomes dry or brittle;
▶ Ensure that the inlet tube is clean;
▶ Use the tube support accessory (provided) and an
appropriate clamp to make the gas inlet connections to the
appliance;
▶ Install a gas shut-off tap as near to the appliance as
possible;
▶ When the gas inlet is connected to the main, metallic tubes
must be used according to the applicable regulations.
– The accessory provided must be used to connect the
heater to the gas main.
– Tighten the threaded head on the gas inlet (Fig. 26,
[1]) and use the copper (Fig. 26, [2]) extremity to
solder the pipe to the main (Fig. 26, [3]).
Fig. 26
[1] Gas piping
Installation instructions | 17
6 720 800 095 (2015/11)
Hide quick links:
Advertisement
Table of Contents
