System Memory Configuration; Install Memory; Upgrade Memory - Shuttle FS56 User Manual

Pentium 4/celeron, 478-pin processor based ddr main board

Hide thumbs Also See for FS56:

Table of Contents

3.3 System Memory Configuration

The FS56 mainboard has two 184-pin DIMM slots that allow you to install from

64MB up to 2GB of system memory.

Each 184-pin DIMM (Dual In-line Memory Module) Slot can accommodate

64MB, 128MB, 256MB, 512MB, and 1GB of PC2100/PC2700 /PC3200 com-

pliant 2.5V single (1 Bank) or double (2 Bank) side 64-bit wide data path DDR

SDRAM modules.

Install memory in any or all of the slots and in any combination shown as

follows.

DIMM Socket

DIMM 1

DIMM 2

Note: Maximum installed memory is 2GB.

Note : You do not need to set any jumper to configure memory since

the BIOS utility can detect the system memory automatically.

You can check the total system memory value in the BIOS

Standard CMOS Setup menu.

You can easily upgrade the system memory by inserting additional DDR SDRAM

modules in available DIMM slots. The total system memory is calculated by

simply adding up the memory in all DIMM slots. After upgrade, the new system

memory value will automatically be computed and displayed in the field " Stan-

dard CMOS Setup" of BIOS setup program.

Memory Modules

16MB, 32MB, 64MB, 128MB, 256MB, 512M ,and 1GB

184-pin 2.5V DDR SDRAM DIMM

16MB, 32MB, 64MB, 128MB, 256MB, 512M ,and 1GB

184-pin 2.5V DDR SDRAM DIMM

- 40 -

Module

Quantity

x 1

Table of Contents