Shuttle FS56 User Manual page 67

All Modes --> Off
Ø The choice: Always On, Suspend ->Off, Susp,Stby -> Off or All
Modes -> Off.
Video Off Method
This determines the manner in which the monitor is blanked.
V/H SYNC+Blank This selection will cause the system to turn off
Blank Screen
DPMS Supported
Ø The choice: V/H SYNC+Blank, Blank Screen, or DPMS Supported.
Switch Function
Enables you to set the System Management Interrupt (SMI) button
function in DOS.
Ø The choice: Disabled or Break / Wake.
MODEM Use IRQ
This determines the IRQ which the MODEM can use.
Ø The choice: 3, 4, 5, 7, 9, 10, 11 or Auto.
HDD Off After
The IDE hard drive will spin down if it is not accessed within a specified
length of time. Options are from 1 Min to 15 Min and Disable.
Ø The choice: Disabled or 1 Min ~ 15 Min.
Power Button Override
Pressing the power button for more than 4 seconds forces the system to
enter the Soft-Off state when the system has "hung".
Ø The choice: Instant Off or Delay 4 Sec.
Power State Resume Control
This item enables your computer to automatically restart or return to its
last operating status after power returns from a power failure.
Ø The choice: Always Off, Always On or Keep Pre-State.
PM Wake Up Events
Options are in its sub-menu.
Press <Enter> to enter the sub-menu of detailed options.
Monitor is blanked when the system enters
any power saving mode.
the vertical and horizontal synchronization
ports and write blanks to the video buffer.
This option only writes blanks to the video
buffer.
Initial display power management signaling.
- 63 -