Shuttle FS56 User Manual page 54

IDE Secondary Slave
Options are in its sub-menu.
Press <Enter> to enter the sub-menu of detailed options.
Drive A/Drive B
Select the type of floppy disk drive installed in your system.
Ø The choice : None, 360K, 5.25 in, 1.2M, 5.25 in, 720K, 3.5 in,
Floppy 3 Mode Support
This Item enable/disable the Floppy mode 3 options. This mode is used
mostly in Japan PC.
Ø The choice: Disabled, Drive A, Drive B or Both.
Video
Select the default video device.
Ø The choice: EGA/VGA, CGA 40, CGA 80 or MONO.
Halt On
Select the situation in which you want the BIOS to stop the POST process
and notify you.
Ø The choice: All Errors, No Errors, All, But Keyboard, All, But
Diskette or All, But Disk/Key.
Base Memory
Displays the amount of conventional memory detected during boot up.
Ø The choice: N/A.
Extended Memory
Displays the amount of extended memory detected during boot up.
Ø The choice: N/A.
Total Memory
Displays the total memory available in the system.
Ø The choice: N/A.
******************************************************
IDE Adapters
The IDE adapters control the hard disk drive. Use a separate sub-menu
to configure each hard disk drive.
IDE HDD Auto-Detection
Press <Enter> to auto-detect HDD on this channel. If detection is suc-
cessful, it fills the remaining fields on this menu.
1.44M, 3.5 in or 2.88M, 3.5 in.
- 50 -