Paper Tape; Loading The Customer Receipt Roll - Olivetti ECR 2500 Euro Instruction Manual

Paper Tape

This cash register uses two rolls of standard 37.5 + 0.5 mm paper.
One roll is is used for the customer receipt while the other roll is used
for the journal record. The paper needs to be changed when a red line
appears on the tape.

Loading the Customer Receipt Roll

Proceed as follows to load a customer receipt roll into the cash
register:
1. Make sure that the cash register is plugged into a grounded power
outlet and that the Control Key is in either one of the two REG
positions.
2. Unlock and remove the printer compartment cover as explained in
the section Installing the Ribbon Cartridge.
3. With a pair of scissors, cut the end of the new paper tape to create a
straight, even edge so that the paper can be properly fed through the
print mechanism.
4. Set the customer receipt roll in its predefined slot at the rear left-
hand side of the printer compartment so that the paper feeds out
from the bottom of the roll. Then insert the end of the paper into the
related paper feed slot, indicated by an arrow on the metal frame, as
shown in the following figure.
A
5. Press the [R feed] key and manually feed the paper into the slot
until its catches and advances approximately six to ten inches above
the print mechanism.
NOTE: If the paper does not feed properly, make sure that the paper
roll is properly aligned in the slot and that the end of the paper
roll is cut straight. If you need to remove the paper tape so that
you can attempt to reload it again, move the plastic release
lever (A) on the side of the metal frame forward, in the
direction of the arrow on the frame, and clear the paper
from the slot.
11