The Inked Ribbon; Paper Tape - Olivetti ECR 2300 Instructions Manual

Installing the Ink Installing the Ink ed Ribbon ed Ribbon
Installing the Inked Ribbon Installing the Ink Installing the Ink ed Ribbon ed Ribbon
Proceed as follows to install the inked ribbon:
1. Unlock, open and remove the printer compartment cover.
2. Remove the paper tape from the print mechanism by sliding it
backwards towards the rear of the cash register.
If dual-ply paper is loaded in the cash register, lift the plastic
journal winder out of the cash register and unwind and free the
journal record from the winder spindle. Then remove the paper tape
from the print mechanism by sliding it backwards towards the rear
of the cash register.
3. Remove the "THANK YOU" stamp as explained in the next section.
4. Remove the used ribbon by lifting the two spools from their related
spindles and the ribbon out of the print mechanism.
5. Place a full spool of ribbon on the left spindle and unwind approxi-
mately three inches of ribbon.
6. Place the ribbon along the outside of the metal brackets and through
the printer mechanism as shown in the following figure.
7. Place the take up spool on the right spindle and then turn it to take
up the slack in the ribbon.
8. Refit the "THANK YOU" stamp.
9. Load the paper tape back into the printer and through the print
mechanism. If the cash register was using dual-ply paper, load the
paper tape back through the print mechanism, and wind the journal
back onto the plastic journal winder spindle. Instructions on how to
load dual-ply paper are provided further on.
10. Reposition, close and lock the printer compartment cover.
11