Electrolux EOC66800 User Manual page 16

16 electrolux
Using the Pyrolytic cleaning
1. Press
again and again until the dis-
play shows
– The display shows PYRO 1 or PYRO
2.
– In 3 seconds the display shows a
message to remove all removable
parts from the appliance.
2. Press
or
the Pyrolytic cleaning:
– P1 2:00 for a low degree of dirt
– P2 2:30 for a high degree of dirt.
3. Press
to start the Pyrolytic cleaning.
The bars on the symbol come on one by
one to show that the temperature in the ap-
pliance increases.
When the appliance is at the preset temper-
ature, the door locks and the display shows
.
When the Pyrolytic cleaning is completed,
the display shows the time of day. The oven
door is locked. When the appliance cools
down, an acoustic signal sounds and the
door unlocks.
To stop the pyrolytic cleaning at any
time, press
End time for Pyrolytic cleaning
You can set the end time for Pyrolytic
cleaning with the clock function End
.
1. Do again step 1, 2 and 3 from
above procedure.
2. Press
.
3. The display shows an arrow
the symbol
the time for the end of Pyrolytic
cleaning.
4. Press
or
the end of the Pyrolytic cleaning.
Pyro reminder
The reminder function tells the user when
pyrolytic cleaning is necessary.
An acoustic signal sounds and the display
shows "Pyro" for approximately 15 sec-
onds.
Set the Pyrolytic cleaning function.
The display shows the reminder mes-
sage when the appliance is off until you
clean the appliance with the Pyrolytic
cleaning.
.
to set the duration for
.
. The display shows
to adjust the time for
Shelf Support Rails
Removing the shelf support rails
1. Pull the front of the shelf support rail
away from the side wall.
2. Pull the rear shelf support rail away from
the side wall and remove it.
Installing the shelf support rails
Install the shelf support rails in opposite se-
quence.
The rounded ends of the shelf support
and rails must point to the front!
Oven lamp
Warning! Be careful! There is the risk
of electrical shock!
Before you change the oven lamp:
• Switch off the oven.
• Remove the fuses in the fuse box or
switch off the circuit breaker.
Put a cloth on the bottom of the oven
for protection of the oven light and
glass cover.
1. Turn the glass cover anti-clockwise to
remove it.
2. Clean the glass cover.