Grounding Procedure (For Flammable Materials Only); Pressure Relief Procedure - Graco LineLazer IV 250SPS Operation
Self-propelled line striper, for the application of line striping materials, for professional use only, for outdoor use only, not for use in hazardous locations or explosive atmospheres, maximum operating speed 10 mph 16 kph, maximum operating pressure: 3
Hide thumbs
Also See for LineLazer IV 250SPS:
- Manual (62 pages) ,
- Repair manual (54 pages) ,
- Installation and operation manual (33 pages)
Table of Contents
Advertisement
Grounding Procedure (For Flammable Materials Only)
Grounding Procedure
(For Flammable Materials Only)
This equipment must be grounded to reduce the risk
of static sparking. Static sparking can cause fumes
to ignite or explode. Grounding provides an escape
wire for the electric current.
1. Position striper so that the tires are not on pave-
ment.
2. Ground sprayer with grounding clamp. Grounding
clamp must attach to grounded object (e.g. metal
sign post).
8
Pressure Relief Procedure
This equipment stays pressurized until pressure is
manually relieved. To help prevent serious injury from
pressurized fluid, such as skin injection, splashing
fluid and moving parts, follow the Pressure Relief
Procedure when you stop spraying and before
cleaning, checking, or servicing the equipment.
1. Perform Grounding Procedure if using flammable
materials.
2. Set pump valve OFF. Turn engine OFF.
3. Turn pressure control to lowest setting. Trigger gun
to relieve pressure.
ti3306a
ti3441a
4. Engage gun trigger safety. Turn prime valve down.
ti6740a
PAINT
ti3324a
3A2090A Operation
ti3305a
ti6473a
Advertisement
Table of Contents
