Driving Instructions; Parking / Emergency Brake - Graco LineLazer IV 250SPS Operation
Self-propelled line striper, for the application of line striping materials, for professional use only, for outdoor use only, not for use in hazardous locations or explosive atmospheres, maximum operating speed 10 mph 16 kph, maximum operating pressure: 3
Hide thumbs
Also See for LineLazer IV 250SPS:
- Manual (62 pages) ,
- Repair manual (54 pages) ,
- Installation and operation manual (33 pages)
Table of Contents
Advertisement
Driving Instructions
Driving Instructions
Perform Startup, page 9.
Use the handle bars of the LineStriper to control all
motion during operation. In addition to steering the
LineStriper, the handle bars also control forward and
reverse movement by pulling the forward/reverse control
lever.
NOTE: Make sure wheel motor bypass valve is engaged
(see page 19).
To move forward: Disengage brake and slowly pull
control lever on right side of handlebar.
To move in reverse: Slowly pull control lever on left
side of handlebar.
To stop: Release control lever and allow it to return to
center.
18
To turn right and left: Turn the handle bar right or left to
steer the LineStriper.
Parking / Emergency Brake
This unit is equipped with a parking brake. Always
engage parking brake when not in operation. Brake may
ti17516a
also be used to stop machine in an emergency situation.
1. Step down on the brake lever to engage parking
brake.
ti17517a
2. Lift brake lever up with foot to disengage parking
brake.
NOTE: Adjust screw for more or less braking force.
ti19115a
ti17518a
ti17519a
ti18550a
+
ti18565a
3A2090A Operation
ti18548a
Advertisement
Table of Contents
