Drive Engagement; Straight Line Adjustment; Handle Bar Height Adjustment - Graco LineLazer IV 250SPS Operation
Self-propelled line striper, for the application of line striping materials, for professional use only, for outdoor use only, not for use in hazardous locations or explosive atmospheres, maximum operating speed 10 mph 16 kph, maximum operating pressure: 3
Hide thumbs
Also See for LineLazer IV 250SPS:
- Manual (62 pages) ,
- Repair manual (54 pages) ,
- Installation and operation manual (33 pages)
Table of Contents
Advertisement
Drive Engagement
The wheel motor bypass valve allows the operator to
disengage the wheel tension and push the unit around.
Rotate one complete turn counter-clockwise to
disengage.
3$
Straight Line Adjustment
The front wheel is set to center the unit and allow the
operator to form straight lines. Over time, the wheel may
become misaligned and will need to be readjusted. To
re-center the front wheel, perform the following steps:
1. Loosen two bolts on the wheel alignment plate.
2. If striper arcs to the right, turn adjuster screw
clockwise.
3A2090A Operation
3. If striper arcs to the left, turn adjuster screw
4. Test-drive the striper. Repeat steps 2 and 3 until
+
ti18576a
Handle Bar Height Adjustment
1. Loosen handlebar height adjuster lock.
2. Raise or lower handlebars to desired height.
ti18586a
3. Tighten handlebar height adjuster lock.
ti18585a
counter-clockwise.
striper drives straight. Tighten two bolts on wheel
alignment plate to lock the new wheel setting.
Driving Instructions
ti18591a
ti18592a
ti18557a
ti18549a
ti18573a
19
Advertisement
Table of Contents
