Reset Device Command - Magtek MICRSAFE Technical Reference Manual

MICRSafe with 3-Track MSR
Example Set Convert To String B property Request (Hex):
Cmd Num
01
Example Set Convert To String B property Response (Hex):
Result Code
00
Example Get Convert To String B property Request (Hex):
Cmd Num
00
Example Get Convert To String B property Response (Hex):
Result Code
00

RESET DEVICE COMMAND

Command number:
Description:
Data structure:
Result codes:
Example Request (Hex):
Cmd Num
02
Example Response (Hex):
Result Code
00
36
Data Len
03
Data Len
00
Data Len
01
Data Len
02
2
This command is used to reset the device's USB CPU. This command can
be used to make previously changed properties take effect without having
to unplug and then plug in the device. When the device resets it
automatically does a USB detach followed by an attach. After the host
sends this command to the device it should close the USB port, wait a few
seconds for the operating system to handle the device detach followed by
the attach and then re-open the USB port before trying to communicate
further with the device.
No data is sent with this command
0 (success)
Data Len
00
Data Len
00
Prp ID Prp Value
1D 0D 0D
Data
Prp ID
1D
Prp Value
0D 0D
Data
Data