Commands; Command 0000 - Get Property; Command 0001 - Set Property; Command 0002 - Reset Device - Magtek iDynamo 5 Gen III Programmer's Manual

4 - Commands

4 Commands
4.1

Command 0000 - Get Property

This command lets the host retrieve a property (see section on properties) from the device using the 1-
byte Property ID.
Table 4-1 Get Property Command
Command Parameter Data Len
0x0000
Table 4-2 Get Property Response
Return Code Response Data Len
0x0000
Legacy (if needed) for simple & short properties.
Table 4-3 Legacy Get Property
Command Parameter Data Len
0x00 0x01
Table 4-4 Legacy Response Structure
Return Code Response Data Len
0x00
4.2

Command 0001 - Set Property

This command sets a property in the device. For secure properties, this command should be the payload
for the Send Secured Command.
Table 4-5 Set Property Command
Command Parameter Data Len
0x0001
Table 4-6 Set Property Response
Return Code Response Data Len
0x0000
4.3

Command 0002 - Reset Device

This command is used to reset the device.
iDynamo 5 Gen III| Secure Card Reader | Programmer's Manual (COMMANDS)
Parameter Data
0x0001 Property ID (1-byte)
Response Data
varies Property Value
Parameter Data
Property ID (1-byte)
Response Data
varies
Parameter Data
Property ID (1 byte)
varies
Property Value (varies)
Response Data
0=Property in effect
0x0001
1=Needs reset
Page 21 of 48 (D998200587-101)
0 to 58 bytes