Rebooting The System; Reloading The Compressed Image - 3Com CoreBuilder 2500 Software Installation And Release Notes

Example
Host IP address [192.9.200.14]: 192.9.200.96
Install file pathname[/usr/cb2500/lp2500c]:
User name: scottco
Password:
Programming flash memory block 1 of 15...
Programming flash memory block 2 of 15...
Programming flash memory block 3 of 15...
.
.
Programming flash memory block 15 of 15...
Installation complete.
6 Proceed to "Rebooting the System" next.

Rebooting the System

To reboot your system, follow these steps:
1 From the top level of the Administration Console, enter:
system reboot
2 When the reboot is complete, log in to the system and proceed to
"Reloading the Compressed Image" next.

Reloading the Compressed Image

You must load the compresed image file again. Follow these steps:
1 From the top level of the Administration Console, enter:
system softwareUpdate
The system prompts you for several items of information.
Press Return at any prompt to accept the default value that is shown in
brackets.
2 At the Host IP address prompt, enter the IP address of the host
device from which you are retrieving the compressed image.
3 At the Install file pathname prompt, enter the complete path
and filename.
Paths and filenames are case-sensitive. Be sure to type them exactly as
shown on the hard disk of the host device.
For an MS-DOS host, you must precede the full path with a forward
slash (/). Example: /c:\3com\cb2500\lp2500c
4 At the User name prompt, enter your user name.
Software Installation Procedure 23