3Com CoreBuilder 2500 Software Installation And Release Notes page 24

24 C B 2500 I
ORE UILDER
Example
S S
NTELLIGENT WITCHING OFTWARE
5 At the Password prompt, enter your password. The field does not
display the characters that you enter.
After you enter your password, the system begins to retrieve the file from
the host device.
When the installation is complete, the system returns you to the top level
of the Administration Console. You do not need to reboot the system.
Host IP address [192.9.200.14]: 192.9.200.96
Install file pathname[/usr/cb2500/lp2500c]:
User name: scottco
Password:
Programming flash memory block 1 of 15...
Programming flash memory block 2 of 15...
Programming flash memory block 3 of 15...
.
.
Programming flash memory block 15 of 15...
Installation complete.
6 You must now reset the password for the administer access level.
Follow these steps:
This step activates patch number 32 in this release. See "About Software
Version 8.1.2" earlier in these release notes for patch descriptions.
a From the top level of the Administration Console, enter:
system password
You are prompted for an access level to change.
b Enter administer
c At the prompt for your old password, enter the old password.
d You are prompted for a new password. Enter a new password.
e At the prompt, enter your new password again.
7 Unlock the Administration Console.
a From the top level of the Administration Console, enter:
system consoleLock
b Enter off
You have completed the installation procedure for Intelligent Switching
software version 8.1.2.
V 8.1.2
ERSION