Start-up
Select function block Fb23.
Activate editing mode for function block Fb23.
Deactivate function block Fb23.
Confirm setting.
Select End on the display.
Exit the configuration level.
Return to the operating level.
Note!
The adjusted sensor values are not reset by the function for resetting to default values.
2.6
Resetting to default values
All parameters and function blocks that can be set without entering the key number can be reset
to their default settings (WE).
Proceed as follows:
Reset to default settings.
Function blocks and parameters are reset to their default settings (WE).
Note!
Resetting protected parameters to their default settings is only possible when the key number is
still active.
The controller is ready for operation with its default settings. You just need to set the correct date
and current time.
24
EB 5474 EN