Displaying Debugging Status; Displaying Operating Information About Modules In System - H3C S3600 Series Operation Manual

Operation Manual – System Maintenance and Debugging
H3C S3600 Series Ethernet Switches-Release 1510

2.3.2 Displaying Debugging Status

Table 2-12 Display the current debugging status in the system
Display
debugging
specified device
Display
debugging in the Fabric by
module

2.3.3 Displaying Operating Information about Modules in System

When an Ethernet switch is in trouble, you may need to view a lot of operating
information to locate the problem. Each functional module has its corresponding
operating information display command(s). You can use the command here to display
the current operating information about the modules in the system for troubleshooting
your system.
Table 2-13 Display the current operation information about the modules in the system.
Display
operation
about the modules in the
system.
Operation
display debugging { fabric |
all enabled
unit
on the
interface-type interface-number
| module-name ]
all enabled
display
by-module
Operation
the current
information display
diagnostic-information
Chapter 2 Basic System Configuration
Command
unit-id } [ interface
debugging fabric
Command
2-6
& Debugging
Description
You can execute
the display
command in
view.
Description
You can use
command in any view.
You should execute this
command twice to find the
difference between the
two executing results,
thus helping locate the
problem.
any
this