H3C S3600 Series Operation Manual page 16

System maintenance and debugging

Hide thumbs Also See for S3600 Series:

Table of Contents

Operation Manual – System Maintenance and Debugging

H3C S3600 Series Ethernet Switches-Release 1510

If the space of the Flash memory is not enough, you can delete the unused files in

the Flash memory before software downloading.

Ensure the power supply during software loading.

II. Loading Procedure Using FTP Server

As shown in Figure 1-9, the switch is used as the FTP server. You can telnet to the

switch, and then execute the FTP commands to download the BootROM program

S3600.btm from the switch.

Loading BootROM

Switch

FTP client

192.168.0.39

Figure 1-9 Remote loading using FTP server

Step 1: As shown in Figure 1-9, connect the switch through an Ethernet port to the PC

(whose IP address is 10.1.1.1)

Step 2: Configure the IP address of VLAN-interface 1 on the switch to 192.168.0.39,

and subnet mask to 255.255.255.0.

Note:

You can configure the IP address for any VLAN on the switch for FTP transmission.

However, before configuring the IP address for a VLAN interface, you have to make

sure whether the IP addresses of this VLAN and PC are routable.

<H3C> system-view

System View: return to User View with Ctrl+Z.

[H3C] interface Vlan-interface 1

[H3C-Vlan-interface1] ip address 192.168.0.39 255.255.255.0

Step 3: Enable FTP service on the switch, and configure the FTP user name to test and

password to pass.

[H3C-Vlan-interface1] quit

[H3C] ftp server enable

Internet

Ethernet port

1-14

Chapter 1 BootROM and Host Software

FTP server

10.1.1.1

Table of Contents