H3C S3600 Series Operation Manual page 33

Operation Manual – System Maintenance and Debugging
H3C S3600 Series Ethernet Switches-Release 1510
Make configuration so that the IP address of a VLAN interface on the switch is
1.1.1.1, the IP address of the PC is 2.2.2.2, and the switch and the PC is reachable
to each other.
The host software switch.bin and the BootROM file boot.btm of the switch are stored in
the directory switch on the PC. Use FTP to download the switch.bin and boot.btm files
from the FTP server to the switch.
II. Network diagram
PC PC PC PC PC PC PC PC
Figure 4-1 Network diagram of FTP configuration
III. Configuration procedure
1) Configure the following FTP server–related parameters on the PC: an FTP user
with the username as switch and password as hello, who is authorized with the
read-write right on the directory Switch on the PC. The detailed configuration is
omitted here.
2) On the switch, configure a level 3 telnet user with the username as user and
password as hello. Authentication mode is by user name and password.
Note:
Refer to the part "Login Operation" for configuration commands and steps about telnet
user.
3) Execute the telnet command on the PC to log into the switch. The following
prompt appears:
<H3C>
Caution:
If the Flash memory of the switch is not sufficient, delete the original applications before
downloading the new ones.
4) Initiate an FTP connection with the following command in user view. Enter the
correct user name and password to log into the FTP server.
Network Network Network Network Network Network Network Network
4-5
Chapter 4 Device Management
Switch Switch Switch Switch Switch Switch Switch Switch Switch Switch Switch Switch