Connecting To The Home Connect App; Activating/Deactivating Wi-Fi - Bosch WAT Series Instruction Manual And Installation Instructions

Home Connect
en
Connecting to the Home
Connect app
Step 3
Make sure that you have opened the
Home Connect app and are logged in.
If your appliance is not automatically
displayed in the app, you can connect
the app as follows:
Switch on the appliance.
1.
Press and hold Remote start for at
2.
least 3 seconds.
'ž£ (connect automatically) will
appear on the display.
Set the programme to position 3.
3.
'˜˜ (connect to app) will appear on
the display.
Press Start/Pause ‹.
4.
The appliance will now connect to your
Home Connect app.
Once your appliance is displayed in
5.
the app, carry out the last steps in
the Home Connect app.
If you were not able to establish
Note:
a connection, check whether your
mobile end device is within range of
your home network or is connected to
this. Try connecting to the
Home Connect app again.
36

Activating/deactivating Wi-Fi

You can switch the Home Connect
function on your appliance on or off
permanently at any time.
Switch on the appliance.
1.
Press and hold Remote start for at
2.
least 3 seconds.
'ž£ (connect automatically) will
appear on the display.
Set the programme to position 4.
3.
'©Ÿ (Wi-Fi function) will appear on
the display.
Press Start/Pause ‹.
4.
If ©Ÿ (switched on) appears on the
display, the Wi-Fi function on the
appliance has been activated. If
©"" (switched off) appears on the
display, the Wi-Fi function is not active.
Press Remote start briefly to exit the
5.
Home Connect settings.
Notes
If you connect to your home network,
■
Wi-Fi is activated automatically.
If Wi-Fi is activated, the appliance will
■
not switch itself off automatically.
If Wi-Fi is switched off on the
■
appliance, it is not possible to use
the Home Connect app to start or
control the appliance remotely.
If Wi-Fi is switched off and your
■
appliance was previously connected
to your home network, this
connection will be re-established
automatically when Wi-Fi is switched
back on.
If you activate this function, the
■
energy consumption increases in
comparison to the values specified
in the consumption value table.