Resetting Your Network Settings; Updating The Software - Bosch WAT Series Instruction Manual And Installation Instructions

Resetting your network
settings
You can clear the network settings and
break the connection to your
smartphone or tablet PC by resetting
the network settings.
Switch on the appliance.
1.
Press and hold Remote start for at
2.
least 3 seconds.
'ž£ (connect automatically) will
appear on the display.
Set the programme to position 5.
3.
§"à (reset network settings) will
appear on the display.
Press Start/Pause ‹.
4.
¢"à (yes) will appear on the display.
Press Start/Pause ‹ within the next
5.
10 seconds to confirm ¢"à (yes).
If this is not confirmed within
Note:
10 seconds, the settings for the
network are not reset.
"Ÿš (end) will appear on the display.
The network settings have now been
reset. Your appliance is no longer
connected to your home network or the
Home Connect app.
Press Remote start briefly to exit the
6.
Home Connect settings.
Notes
If the network settings could not be
■
reset, "§§ (fault) will appear on the
display.
If you want to operate the appliance
■
via the Home Connect app again,
you will need to reconnect it to your
home network and to the
Home Connect app either
automatically or manually.

Updating the software

You can update the Home Connect
software on your appliance. Whenever a
new update is available, —˜š (update)
will appear on the display.
You can install the update directly via
the message on the display or,
alternatively, you can do this manually.
Switch on the appliance.
1.
Press and hold Remote start for at
2.
least 3 seconds.
'ž£ (connect automatically) will
appear on the display.
Set the programme to position 6.
3.
—˜š (software update) will appear
on the display.
Start/Pause ‹ will flash if a software
update is available.
Press Start/Pause ‹.
4.
¢"à (yes) will appear on the display.
Press Start/Pause ‹ within the next
5.
10 seconds to confirm ¢"à (yes).
If you do not confirm within
Note:
10 seconds, the software will not
begin updating.
Update installation will now start. This
process may take several minutes. Do
not switch the appliance off while
updates are being installed.
If the update is complete, "Ÿš (end) will
appear on the display.
Press Remote start briefly to exit the
6.
Home Connect settings.
If a problem occurred when
Note:
updating the software, "§§ (error) will
appear on the display.
Home Connect
en
37