Childlock/Operation Lock; Adding Laundry - Bosch WAT Series Instruction Manual And Installation Instructions

Up to 8kg
Table of Contents

Advertisement

Operating the appliance
en
During the programme, the current
programme information is displayed:
Finished in-timeFinished in-time or,
after the washing programme has
started, the programme duration
And the displays for the
programme's progress light up.
~ Page 21
Information on the following programme
steps and settings, which can be
changed during the programme
sequence, light up at half brightness.
Note:
Foam detection
If the Å display also lights up, the
washing machine has detected too
much foam during the washing
programme and automatically activated
additional rinse cycles to remove the
foam.
Add less detergent to the next washing
cycle with the same load.
If you want to lock the programme to
prevent it from being inadvertently
adjusted, you can select the childproof
lock as follows.

Childlock/operation lock

E 3 sec
You can lock the washing machine to
prevent the functions you have set from
being changed inadvertently in the
control panel.
To activate/deactivate the childproof
lock, touch and hold the control panel
E 3 sec for approx. three seconds. The
display switches to full brightness.
If you turn the programme selector or
touch the control panel while the
childproof lock is active, the E 3 sec
indicator will flash briefly and a signal
will sound. The programme runs
through to the end unchanged.
32
Notes
To remove the laundry at the end of
the programme, deactivate the
childproof lock.
The childproof lock can be activated
no matter what status the appliance
is in.
The childproof lock remains active,
even once the washing machine has
been switched off.
If the appliance is switched off while
the programme is running and
childproof lock is activated, the
programme continues when the
appliance is switched back on.

Adding laundry

After starting the programme, you can
add or remove laundry if necessary.
To do this, touch the control panel A.
The indicator flashes. The machine is
paused and checks whether a top-up is
possible.
If the display è goes out, a top-up is
possible. The door is then unlocked and
can be opened.
To continue the programme. touch A
again. The programme continues
automatically.
Notes
Do not leave the door open for too
long when adding laundry as water
from the laundry may leak out.
For safety reasons, the door remains
locked when the water level or
temperature is high, or while the
drum is turning, and it is not possible
to add laundry during this time.
Follow the information on the display
panel.
The load display is not active during
reloading.

Advertisement

Table of Contents
loading

Table of Contents