Ready In Time; I-Dos Settings - Bosch WAT Series Instruction Manual And Installation Instructions

Ready in time

After selecting a programme, the
programme duration is displayed, e.g.
1:51 (in h:min (hours:minutes)).
Before the programme starts, you can
move the time at which the programme
should be finished backwards, in
increments of 30 minutes and up to a
maximum of 24 h (h=hour).
After the programme starts, the
selected time, e.g. 8.5 h is displayed
and counted down until the washing
programme starts. The duration of the
programme is then displayed.
The programme duration is
Note:
automatically adjusted when the
programme is running. Changes to the
programme default settings or
programme settings, foam detection
function, unbalanced load detection, the
load or soiling may also change the
programme duration.
After the programme starts, and while
the selected time is counting down, you
can change this as follows:
Touch the control panel A.
1.
Touch N or M to change the time.
2.
And touch A again.
3.
After starting the programme, while the
programme is running, you can add or
remove laundry if necessary.
~ Page 32
Programme default settings

i-DOS settings

Your washing machine has an intelligent
dosing system for liquid detergent and
fabric softener.
The washing machine doses your
detergent and fabric softener
automatically in most programmes.
The following have been preset at the
factory:
w i-DOS: L
■
Detergent dosage for lightly soiled
laundry
i i-DOS: K
■
Fabric softener dosage for a
medium level of softness
i-DOS w for detergent
Adjustment values for the dosage
quantity
Light:
L
For lightly soiled laundry
Medium:
K
For normally soiled laundry
Heavy:
J
For particularly heavy soiling and/
or staining
off Automatic dosing deselected,
manual dosage ~ Page 43
You can change the settings for
automatic detergent dosing before the
washing programme starts and during
pre-wash (if selected). Touch the control
panel i-DOS w for this.
You can find information on degrees of
soiling on ~ Page 26.
en
27