The Drain Hose At The Siphon Is Blocked; Filter In The Water Supply Blocked - Bosch WAT Series Instruction Manual And Installation Instructions

To prevent unused detergent
Note:
from flowing straight into the drain
during the next wash: Pour 1 litre of
water into the left-hand compartment
and start the programme Drain/Empty.
The drain hose at the siphon
is blocked
Switch off the appliance. Pull out the
1.
mains plug.
Loosen the hose clamp. Carefully
2.
remove the drain hose; residual
water may leak out.
Clean the drain hose and siphon
3.
connecting piece.
Re-attach the drain hose and secure
4.
the connection point using the hose
clamp.
Cleaning and maintenance
Filter in the water supply
blocked
Release water pressure in the supply
1.
hose:
a) Turn off the tap.
b) Select any programme (except
Rinse/Spin/Drain/Empty).
c) Start the programme and leave it
to run for approx. 40 seconds.
d) Switch off the appliance.
e) Pull out the mains plug.
Clean the filters:
2.
a) Disconnect the hose from the
tap.
Clean the filter with a small brush.
b) For standard and Aqua-Secure
models, clean the filter on the
rear of the appliance:
Disconnect the hose from the
rear of the appliance.
Use pliers to remove the filter and
then clean it.
c) Connect the hose and check for
leaks.
en
49