Energy Management - Bosch WAT Series Instruction Manual And Installation Instructions

Home Connect
en

Energy management

You can connect your appliance to your
smart energy system (Energy manager).
Once you have connected your
appliance to the smart energy system
(Energy manager) and activated the
Flex Start function, you will be able to
optimise your energy consumption
because your appliance will not start up
until your home photovoltaic system can
provide sufficient energy or the energy
tariff is good.
Further information and system
requirements for using the Energy
manager can be found at: www.home-
connect.com/energymanagement
Notes
The smart energy system (Energy
■
manager) must use the EEBus
initiative communications standard.
Before you start, read the smart
■
energy system instruction manual to
find out how to connect your
appliance to the smart energy
system (Energy manager).
You can connect Flex Start to the
smart energy system (Energy
manager) as follows:
Switch on the appliance.
1.
Press and hold Remote start for at
2.
least 3 seconds.
'ž£ (connect automatically) will
appear on the display.
Set the programme to position 7.
3.
"Ÿ® (Energy manager) will appear
on the display.
Press Start/Pause ‹.
4.
38
The appliance will now connect to your
smart energy system (Energy manager).
If the appliance has connected to the
smart energy system (Energy manager)
successfully, '©Ÿ (connected) and ±
will appear on the display.
If the appliance has previously been
connected to the smart energy system
(Energy manager), you have
disconnected the appliance from the
smart energy system (Energy manager).
©"" will appear on the display.
Press Remote start briefly to exit the
5.
Home Connect settings.
Notes
If a connection to the Energy
■
manager could not be established,
"§§ (error) will appear on the
display.
Check that the Energy manager has
■
been correctly installed.
Try connecting to the Energy
■
manager again.
Flex Start
Activate the Flex Start function to allow
your smart energy system (Energy
manager) to start your appliance once
your home photovoltaic system is able
to provide sufficient energy or the
energy tariff is good.
Your smart energy system
Note:
(Energy manager) cannot start your
appliance until it is connected to the
appliance.
Activate Flex Start as follows:
Select the programme you require.
1.
Use the ˜ and ª selection buttons
2.
for the "Finished in" time to set the
required time.
ð ‰.†œ appears on the display, for
example.
Press Start/Pause ‹.
3.
Press Remote start.
4.