Hunter GSP9720JLR Operation Instructions Manual page 62

CAUTION:
54 x Balancing Procedures
The BDC laser locator automatically displays a vivid line at bottom dead center after
a wheel has been spun. The laser turns off when the wheel is spun again.
Use of controls or adjustments or performance of procedures other than
those specified herein may result in hazardous radiation exposure.
With the servo enabled, attach the adhesive weight using the weight amount shown
for the right weight plane on the LCD. Refer to "Servo-Aided Adhesive Weight
Placement," page 61. If servo is not enabled, BDC placement should be used. Refer
to "Manual Weight Position Measurement," page 59.
If necessary, use the right "
Feature," page 82.
Left and right weight plane displays should show "OK" after check spin.
MIXED WEIGHTS balancing procedure is complete.
" to split the weight. Refer to "Split Weight®
GSP9720JLR Wheel Balancer Operation Instructions