Hunter GSP9720JLR Operation Instructions Manual page 25

Switching from SmartWeight
Dynamic Balancing Modes
GSP9720JLR Wheel Balancer Operation Instructions
Prior to balance spin, the tire graphs will display no color. The SmartWeight balance
force graphs will display red for excessive forces and green for acceptable amounts
of force. If the SmartWeight balancing procedure requires correction weights wheel
dimensions will be required. Enter the dimensions using the Dataset
The screen will display the amount and location of corrective weight necessary.
Install the weights in the appropriate manner using the correct type of weight and
lower the hood to re-spin and check the balance. Instead of displaying zeros in the
weight display, SmartWeight balancing displays "OK," indicating that the force levels
are reduced to within the acceptable tolerances.
NOTE: To quickly exit SmartWeight and force a static balance, input
the one static plane twice tapping the foot pedal twice
(without moving the dataset arm). Respond "yes" to the
confirmation screen to exit SmartWeight. The balancer will
revert back to SmartWeight upon another dimension entry or
a reset.
At any time, SmartWeight balancing technology can be switched to standard
balancing as long as both standard and SmartWeight balancing modes are enabled
in setup.
Press and hold down the knob until SmartWeight balancing is highlighted. Once
highlighted, press and hold the knob till the standard balance icons appear. Cycle
back the same way.
NOTE: SmartWeight balancing technology is the default balancing
method and is the most recommended way to accurately
balance wheel/tire assemblies.
®
Balancing Technology to Traditional
®
arms.
Introduction to Balancing x 17