Hunter GSP9720JLR Operation Instructions Manual page 59

GSP9720JLR Wheel Balancer Operation Instructions
Use both Dataset® arms in the UPWARD position at the clip-on weight location to
measure the distance, diameter, and rim width dimensions. Refer to "Automatic
Dataset® Arms Operation," page 59.
NOTE: The Dataset® Arms should be positioned in the location for
weight placement. Refer to "Measuring Dimensions for
Standard Clip-on Weight Balancing," page 60.
Enter the data by depressing the foot pedal. Release the Dataset® arms.
Close safety hood.
Press the green "START" button if "Hood Autostart" is disabled.
After wheel comes to a complete stop, raise the safety hood.
The GSP9720JLR will find the TDC for the left weight plane if "Servo-Stop" is
enabled. "Servo-Stop" will hold the wheel in the TDC position while the weight is
applied. The weight amount will be displayed in green.
Attach the weight amount shown on the LCD for the left weight plane to the inner rim
of the wheel.
NOTE: If optional HammerHead™ TCD weight locator is installed,
the weight should be applied at the location marked by the
laser. Refer to "3.23 Optional HammerHead™ TDC Laser
Adhesive Weight Locator," on page 76.
If necessary, use the left "
Feature," page 66.
" to split the weight. Refer to "Split Weight
®
Balancing Procedures x 51