Hunter GSP9720JLR Operation Instructions Manual page 105

GSP9720JLR Wheel Balancer Operation Instructions
After tagging the second tire/wheel assembly, the vehicle plan view will appear. Refer
to "Vehicle Plan View," page 98.
NOTE: The "Vehicle Plan View," showing tire/wheel assembly
placement will appear only after two or more tire/wheel
assemblies have been measured.
The vehicle plan view will show the net tire pull for the two measured tire/wheel
assemblies.
Press "Continue" to return to the balance screen.
Mount the third tire/wheel assembly on the
(if needed) and balancing.
Press "Tire Tags" to number the third tire/wheel assembly. The screen will
default to tag 3.
Press "OK" to accept tag 3. Refer to "Changing Tag Numbers," page 99. After
tagging the third tire/wheel assembly, the vehicle plan view will reappear. Refer to
"Vehicle Plan View," page 98. The vehicle plan view will show suggested placement
of the tire/wheel assemblies so that the net lateral force, produced by tire conicity,
exerted on the steer axle of the vehicle is minimized.
Press "Exit" to return to the balance screen.
Mount the fourth tire/wheel assembly on the
Forcematching (if needed) and balancing. Press "Tire Tags" to identify the tire/wheel
assembly. The screen will default to tag 4. Press "OK" to accept tag 4. Refer to
"Changing Tag Numbers," page 99. After tagging the fourth tire/wheel assembly, the
vehicle plan view will reappear. Refer to "Vehicle Plan View," page 98.
On the Vehicle Plan View screen, various choices of tire placement may be chosen
to optimize the vehicle for least pull and/or least vibration.
GSP9720JLR and perform Forcematching
GSP9720JLR and perform
Road Force® Measurement Procedures x 97