®
®
XBee
/XBee‐PRO
ZB RF Modules
For more information relating to European compliance of an OEM product incorporating the XBee RF
Module, contact Digi, or refer to the following web sites:
CEPT ERC 70-03E - Technical Requirements, European restrictions and general requirements: Available at
www.ero.dk/.
R&TTE Directive - Equipment requirements, placement on market: Available at www.ero.dk/.
Antennas
The following antennas have been tested and approved for use with the embedded XBee RF Module:
- Dipole (2.1 dBi, Omni-directional, Articulated RPSMA, Digi part number A24-HABSM)
- PCB Antenna (0.0 dBi)
- Monopole Whip (1.5 dBi)
Canada (IC)
Labeling Requirements
Labeling requirements for Industry Canada are similar to those of the FCC. A clearly visible label
the outside of the final product enclosure must display the following text.
For XBee ZB Surface Mount:
Contains Model XBee S2C Radio, IC: 1846A-XBS2C
The integrator is responsible for its product to comply with IC ICES-003 & FCC Part 15, Sub. B -
Unintentional Radiators. ICES-003 is the same as FCC Part 15 Sub. B and Industry Canada accepts FCC
test report or CISPR 22 test report for compliance with ICES-003.
For XBee-PRO ZB Surface Mount:
Contains Model XBee-PRO S2C Radio, IC: 1846A-PS2CSM
The integrator is responsible for its product to comply with IC ICES-003 & FCC Part 15, Sub. B -
Unintentional Radiators. ICES-003 is the same as FCC Part 15 Sub. B and Industry Canada accepts FCC
test report or CISPR 22 test report for compliance with ICES-003.
Note: Legacy XBee-PRO SMT (hardware version 21xx) has IC: 1846A-XBPS2C
For XBee ZB Through Hole:
Contains Model S2CTH Radio, IC: 1846A-S2CTH
The integrator is responsible for its product to comply with IC ICES-003 & FCC Part 15, Sub. B -
Unintentional Radiators. ICES-003 is the same as FCC Part 15 Sub. B and Industry Canada accepts FCC
test report or CISPR 22 test report for compliance with ICES-003.
For XBee-PRO ZB Through Hole:
Contains Model PS2CTH Radio, IC: 1846A-PS2CTH
The integrator is responsible for its product to comply with IC ICES-003 & FCC Part 15, Sub. B -
Unintentional Radiators. ICES-003 is the same as FCC Part 15 Sub. B and Industry Canada accepts FCC
test report or CISPR 22 test report for compliance with ICES-003.
Transmitters for Detachable Antennas
This device has been designed to operate with the antennas listed in the previous table and having a
maximum of 19 dB. Antennas not included in this list or having a gain greater than 19 dB are strictly
prohibited for use with this device. The required antenna impedance is 50 ohms.
Detachable Antenna
To reduce potential radio interference to other users, the antenna type and gain should be so chosen that
the equivalent, istropically radiated power (EIRP) is not more than permitted for successful communication.
© 2014 Digi International Inc.
on
173